2017A&A...608A.136P


Query : 2017A&A...608A.136P

2017A&A...608A.136P - Astronomy and Astrophysics, volume 608A, 136-136 (2017/12-1)

LEAP: Looking beyond pixels with continuous-space EstimAtion of Point sources.

PAN H., SIMEONI M., HURLEY P., BLU T. and VETTERLI M.

Abstract (from CDS):

Context. Two main classes of imaging algorithms have emerged in radio interferometry: the CLEAN algorithm and its multiple variants, and compressed-sensing inspired methods. They are both discrete in nature, and estimate source locations and intensities on a regular grid. For the traditional CLEAN-based imaging pipeline, the resolution power of the tool is limited by the width of the synthesized beam, which is inversely proportional to the largest baseline. The finite rate of innovation (FRI) framework is a robust method to find the locations of point-sources in a continuum without grid imposition. The continuous formulation makes the FRI recovery performance only dependent on the number of measurements and the number of sources in the sky. FRI can theoretically find sources below the perceived tool resolution. To date, FRI had never been tested in the extreme conditions inherent to radio astronomy: weak signal/ high noise, huge data sets, large numbers of sources.
Aims. The aims were (i) to adapt FRI to radio astronomy, (ii) verify it can recover sources in radio astronomy conditions with more accurate positioning than CLEAN, and possibly resolve some sources that would otherwise be missed, (iii) show that sources can be found using less data than would otherwise be required to find them, and (iv) show that FRI does not lead to an augmented rate of false positives.
Methods. We implemented a continuous domain sparse reconstruction algorithm in Python. The angular resolution performance of the new algorithm was assessed under simulation, and with visibility measurements from the LOFAR telescope. Existing catalogs were used to confirm the existence of sources.
Results. We adapted the FRI framework to radio interferometry, and showed that it is possible to determine accurate off-grid point-source locations and their corresponding intensities. In addition, FRI-based sparse reconstruction required less integration time and smaller baselines to reach a comparable reconstruction quality compared to a conventional method. The achieved angular resolution is higher than the perceived instrument resolution, and very close sources can be reliably distinguished. The proposed approach has cubic complexity in the total number (typically around a few thousand) of uniform Fourier data of the sky image estimated from the reconstruction. It is also demonstrated that the method is robust to the presence of extended-sources, and that false-positives can be addressed by choosing an adequate model order to match the noise level.

Abstract Copyright: © ESO, 2017

Journal keyword(s): techniques: interferometric - methods: numerical - techniques: image processing - techniques: image processing

Simbad objects: 1

goto Full paper

goto View the references in ADS

Number of rows : 1
N Identifier Otype ICRS (J2000)
RA
ICRS (J2000)
DEC
Mag U Mag B Mag V Mag R Mag I Sp type #ref
1850 - 2023
#notes
1 ClG J0603.3+4214 ClG 06 03.3 +42 14           ~ 116 0

Query : 2017A&A...608A.136P

Basic data :
ClG J0603.3+4214 -- Cluster of Galaxies
Origin of the objects types :

(Ref) Object type as listed in the reference "Ref"
(acronym) Object type linked to the acronym according to the original reference
() Anterior to 2007, before we can link the objet type to a reference, or given by the CDS team in some particular cases

Other object types:
ClG (2012ApJ,ClG,...), C?G (2014A&A), X (RX)
Syntax of coordinates is : "ra dec (wtype) [error ellipse] quality bibcode" :
  • ra dec : right ascension and declination (unit and frame defined according to your Output Options)
    Grey values are increasing the original precision due to the computation of frame transformations
  • (wtype) : wavelength class for the origin of the coordinates (Rad, mm, IR, Optical, UV, Xray, Gam)
  • [error ellipse] : measurement uncertainty, on (ra,dec) if the positional angle is 90 degrees, on (majaxis,minaxis) otherwise (in mas at defined epoch in the original catalogue),
    position angle (in degrees North celestial pole to East)
  • quality : flag of quality
    • E ≥ 10"
    • D : 1-10" (and some old data)
    • C : 0.1-1"
    • B : 0.01-0.1" + 2MASS, Tyc
    • A : VLBI, Hipparcos
  • bibcode : bibcode of the coordinates reference
ICRS coord. (ep=J2000) :
06 03 18.0 +42 14 00 [ ] D 2013AN....334..333R
Syntax of coordinates is : "ra dec (wtype) [error ellipse] quality bibcode" :
  • ra dec : right ascension and declination (unit and frame defined according to your Output Options)
    Grey values are increasing the original precision due to the computation of frame transformations
  • (wtype) : wavelength class for the origin of the coordinates (Rad, mm, IR, Optical, UV, Xray, Gam)
  • [error ellipse] : measurement uncertainty, on (ra,dec) if the positional angle is 90 degrees, on (majaxis,minaxis) otherwise (in mas at defined epoch in the original catalogue),
    position angle (in degrees North celestial pole to East)
  • quality : flag of quality
    • E ≥ 10"
    • D : 1-10" (and some old data)
    • C : 0.1-1"
    • B : 0.01-0.1" + 2MASS, Tyc
    • A : VLBI, Hipparcos
  • bibcode : bibcode of the coordinates reference
FK4 coord. (ep=B1950 eq=1950) :
05 59 43.6 +42 14 07 [ ]
Syntax of coordinates is : "ra dec (wtype) [error ellipse] quality bibcode" :
  • ra dec : right ascension and declination (unit and frame defined according to your Output Options)
    Grey values are increasing the original precision due to the computation of frame transformations
  • (wtype) : wavelength class for the origin of the coordinates (Rad, mm, IR, Optical, UV, Xray, Gam)
  • [error ellipse] : measurement uncertainty, on (ra,dec) if the positional angle is 90 degrees, on (majaxis,minaxis) otherwise (in mas at defined epoch in the original catalogue),
    position angle (in degrees North celestial pole to East)
  • quality : flag of quality
    • E ≥ 10"
    • D : 1-10" (and some old data)
    • C : 0.1-1"
    • B : 0.01-0.1" + 2MASS, Tyc
    • A : VLBI, Hipparcos
  • bibcode : bibcode of the coordinates reference
Gal coord. (ep=J2000) :
170.2156 +09.7353 [ ]
Syntax of radial velocity (or/and redshift) is : "value [error] (wavelength) quality bibcode"
  • value : radial velocity or/and redshift (Heliocentric frame) according to your Output Options
    (redshift may be not displayed if the data value is <0 and the database inside value is a radial velocity)
  • [error] : error of the corresponding value displayed before
  • (wavelength) : wavelength range of the measurement : Rad, mm, IR, Opt, UV, Xray, Gam or  '∼'(unknown)
  • quality : flag of quality ( A=best quality -> E=worst quality, {� } =unknown quality)
  • bibcode : bibcode of the value's origin
Radial velocity / Redshift / cz :
V(km/s) 60722 [~] / z(spectroscopic) 0.2280 [~] / cz 68353 [~]
   D 2015A&A...581A..14P
SIMBAD within arcmin
', {sourceSize:12, color:'#30a090'})); aladin.on('objectClicked', function(object) { var objName=object.data.MAIN_ID; aladin.showPopup(object.ra,object.dec,'',''+ objName+''); });" title="Show Simbad objects"> Overlay Simbad points in this preview
Back
All CDSPortal (CDSPortal)

Send to sendBySAMP sendBySAMP

sedIcon
within arcsec The VizieR photometry tool allows for easy visualization of photometry points extracted around the Simbad position from photometry-enabled catalogues in VizieR.
The search radius has to be specified by the user. It is currently limited to a maximum of 30 arcsec. It depends mostly on the precision or quality of the coordinates (SIMBAD and VizieR catalogs), the resolution of the images from which the sources were extracted, source extent, and source crowding.
Suggestions are: crowded field: 0.5 to 1.5 arcsec, 3 arcsec otherwise; uncertain coordinates (SIMBAD quality E or coordinates without reference): 5 to 30 arsec (risky!).
sed-help-icon

Hierarchy : number of linked objects
whatever the membership probability is (see description here ) :

The count displayed here is the number of children objects.
The list obtained by clicking the button may be larger, as some children may be linked with different references or probability.

%This number is the number of distinct objets linked, by using this button, you will obtain all links (may be more than one) from that object to his children

: 243
Display criteria :

The link on the acronym of the identifiers give access to the information for this acronym in the dictionary of nomenclature.
Identifiers (5) :
An access of full data is available using the icon Vizier near the identifier of the catalogue

ClG J0603.3+4214 PSZ1 G170.22+09.74 RX J0603.3+4214
NAME Toothbrush Cluster PSZ2 G170.22+09.74

References (116 between 1850 and 2023) (Total 116)
Simbad bibliographic survey began in 1850 for stars (at least bright stars) and in 1983 for all other objects (outside the solar system).
Follow new references on this object
                Reference summaries :

                from: to:

                 or select by : (not exhaustive, explanation here)


Collections of Measurements


velocities : 1   

   


External archives :

Archive data at HEASARC - High-Energy Astrophysics Science Archive Research Center

Data at NED - NASA/IPAC Extragalactic Database : ClG J0603.3+4214


Annotations :
Annotations allow a user to add a note or report an error concerning the astronomical object and its data. It requires registration to post a note. See description .
Please, have a look at Best practices. The list of all annotations to SIMBAD objects can be found here .

Currently no annotations available

add an annotation to this object

report an error concerning the data of this object


To bookmark this query, right click on this link: simbad:objects in 2017A&A...608A.136P and select 'bookmark this link' or equivalent in the popup menu


2022.12.09-06:01:02

© Université de Strasbourg/CNRS

    • Contact