2007A&A...463..297S

We extend semi-analytical computations of excitation rates for solar oscillation modes to those of other solar-like oscillating stars to compare them with recent observations Numerical 3D simulations of surface convective zones of several solar-type oscillating stars are used to characterize the turbulent spectra as well as to constrain the convective velocities and turbulent entropy fluctuations in the uppermost part of the convective zone of such stars. These constraints, coupled with a theoretical model for stochastic excitation, provide the rate P at which energy is injected into the p-modes by turbulent convection. These energy rates are compared with those derived directly from the 3D simulations. The excitation rates obtained from the 3D simulations are systematically lower than those computed from the semi-analytical excitation model. We find that P_max, the P maximum, scales as (L/M)^s where s is the slope of the power law and L and M are the mass and luminosity of the 1D stellar model built consistently with the associated 3D simulation. The slope is found to depend significantly on the adopted form of χ_k, the eddy time-correlation; using a Lorentzian, χ_k^L, results in s=2.6, whereas a Gaussian, χ_k^G, gives s=3.1. Finally, values of V_max, the maximum in the mode velocity, are estimated from the computed power laws for P_max and we find that V_max increases as (L/M)^sv. Comparisons with the currently available ground-based observations show that the computations assuming a Lorentzian χ_k yield a slope, sv, closer to the observed one than the slope obtained when assuming a Gaussian. We show that the spatial resolution of the 3D simulations must be high enough to obtain accurate computed energy rates.